Preparation is Key
Proper surface preparation is critical for ensuring reflective tape adheres correctly and performs optimally throughout its service life.
Surface Requirements
- Clean and dry surface
- Free of grease, oil, and wax
- Free of loose paint and rust
- Temperature between 15°C and 30°C for installation
Installation Steps
- Clean the application surface with isopropyl alcohol
- Measure and mark the tape position according to regulations
- Peel the backing paper gradually as you apply
- Apply firm pressure using a squeegee or roller
- Ensure no air bubbles are trapped underneath
- Allow 24 hours for full adhesive bond formation
Common Mistakes to Avoid
- Applying on dirty or wet surfaces
- Stretching the tape during application
- Not applying adequate pressure
- Installing in extreme temperatures
Following these best practices will ensure your reflective tape provides maximum visibility and meets regulatory requirements for years to come
